Ramsey Electronics BS1 Bedienerhandbuch PDF herunterladen (Seite 26)

SG7• 26

 6. Make a final check for straightness and antenna positioning.

 7. Solder all 4 sides of the oscillator assembly to the can. A solid solder

seam is as important for range as it is for mechanical strength. The solder

must run fully along all edges where the oscillator box touches the can.

Flow enough solder to fill in any can ribbing under the oscillator box.

 8. Do not paint the oscillator assembly until you are positive that your SG7

is functioning as specified. Otherwise, any desoldering required will be

needlessly complicated and messy.

MICROWAVE OSCILLATOR SCHEMATIC DIAGRAM:

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 35 36

Keine Kommentare

Ramsey Electronics BS1 Bedienerhandbuch Seite 26